Dishwasher Repair in Falls Church, VA

A dishwasher runs a repeating cycle of filling, spraying hot water through rotating arms, draining, and repeating for wash and rinse stages, all timed and sequenced by a control board reading a water-level float switch and (on newer units) a turbidity sensor that judges how dirty the water is. Because the wash and drain systems are largely separate, a dishwasher can drain perfectly fine while cleaning poorly, or clean fine while failing to drain — which is why 'my dishwasher is broken' covers several distinct, separately-diagnosable problems.

A dishwasher that won't drain or leaves standing water is most often a clogged drain pump or filter basket (food debris is the top cause, especially in households that don't pre-scrape dishes), a kinked or improperly looped drain hose, or in some installations, an air gap or garbage disposal knockout plug that was never removed during installation. We check the simplest, cheapest cause first — the filter basket, which most homeowners have never removed and cleaned — before moving to the pump.

Dishes coming out dirty or filmy despite a completed cycle usually traces back to clogged spray arm jets (mineral deposits or food particles blocking the small holes), a worn wash pump that can't build enough water pressure, or water that isn't reaching an adequate temperature — dishwashers rely on the home's hot water supply reaching the unit hot, so a water heater set too low can look exactly like a dishwasher malfunction. A white filmy residue specifically is usually hard water mineral buildup rather than a mechanical fault, and is solved with a rinse-aid adjustment or an occasional citric-acid cleaning cycle rather than a repair.

Leaks show up in three places, each with a different cause: under the door (a worn door gasket, or a rack rail that's rubbing and damaging the gasket over time), underneath the unit (a cracked tub, a loose hose clamp, or a failing pump seal), or into the cabinet below (usually a drain-side or supply-side connection issue from the original installation). We trace the water path during a running cycle rather than guessing from where puddles appear, since dishwasher leaks are notorious for showing up several feet from their actual source.

Most dishwasher repairs — pumps, spray arms, door seals, inlet valves, control boards — are same-visit jobs and are almost always worth doing rather than replacing, since even a control board replacement is typically a fraction of a new unit's cost, and that math tilts even further toward repair for built-in panel-ready or luxury brand (Miele, Bosch, KitchenAid) dishwashers designed to match custom cabinetry.

To keep a dishwasher running well: clean the bottom filter basket monthly (this single habit prevents most drainage and odor complaints), scrape but don't over-rinse dishes before loading (some food residue actually helps the turbidity sensor calibrate the cycle correctly), run a citric-acid or dishwasher-cleaner cycle every few months if your water is hard, and check that spray arms spin freely and aren't hitting oversized dishes, which is a common cause of arm and motor wear over time.

It's also worth paying attention to loading habits: blocking the spray arm's rotation with a tall pot or oversized platter is one of the most common reasons a full load comes out with some dishes clean and others not, and it's mistaken for a mechanical problem far more often than it's reported as a loading issue. Similarly, using rinse aid consistently does more than reduce spotting — it helps water sheet off surfaces during the dry cycle, which reduces the standing moisture that can otherwise contribute to musty odors between cycles.

One more habit worth building in: run the hot water tap at the kitchen sink for a few seconds before starting a dishwasher cycle, especially if the dishwasher is on a long supply run from the water heater. Dishwashers don't heat cold water the way some homeowners assume — they rely largely on the hot water already coming through the supply line — so starting a cycle with cold water sitting in the pipe means the first several minutes of the wash run cooler than intended, which shows up as underwhelming cleaning performance that has nothing to do with the machine itself.